Fully insured · Free estimates · Panel upgrade specialists Mon–Sat · 8:00am–6:00pm
(412) 899-2364 Get a Quote

Our specialty · 100A · 150A · 200A · 400A

Panel & Service Upgrades

This is the work we do most and the work we do best. If your panel is full, hot to the touch, or still the original from when the house was built, it is not keeping up with a modern house. We size the new service properly, pull the permit, coordinate the utility disconnect and reconnect, label every circuit, and leave you with capacity you can actually build on.

(412) 899-2364 Request an Estimate

Electric Power Pro Solutions · McKeesport, PA 15132 · (412) 899-2364

A newly installed 200-amp residential load center with conductors dressed and every circuit labeled

What’s included

  • Full service upgrades — 100A, 150A, 200A and 400A
  • Load calculations done before we quote, not after
  • Main breaker panel and load center replacement
  • Meter socket, mast and service entrance cable replacement
  • Sub-panels for additions, garages and finished basements
  • Whole-home surge protection at the panel
  • Permit pulled and inspection scheduled — we handle it
  • Utility coordination for the disconnect and reconnect
  • Every circuit traced and labeled before we leave

Why it matters

Electrical work is one of the few trades where the difference between good and bad is invisible until it isn’t. A job done properly is permitted, inspected, correctly grounded and bonded, sized for what you actually run, and labeled so the next person — another electrician, a home inspector, the next owner — can read it without guessing.

That is the standard on every job we take, whether it is a single circuit or a full service replacement. We would rather do fewer jobs properly than more jobs quickly.

Where we do this work

Greater Pittsburgh and the whole Mon Valley out of our base in McKeesport, reaching ten counties in all — Allegheny, Westmoreland, Washington, Fayette, Armstrong, Indiana, Butler, Beaver, Greene and the corner of Somerset. See the full service area map.

Straight answers

Common questions

How much does an electrical panel upgrade cost in the Pittsburgh area?

It depends on the service size, the condition of the existing service entrance and what your municipality charges for the permit. That is why we look at it in person and give you one written number covering labour, materials, permit and inspection before any work starts. The estimate is free.

How long does a panel upgrade take?

Most residential service upgrades are a single day. The power is off for part of that day while the utility disconnects and reconnects, and we schedule that window in advance so you can plan around it.

Do I need a permit to replace my electrical panel?

Yes. A service or panel replacement is permitted and inspected work everywhere in our service area. We pull the permit, meet the inspector and hand you the paperwork, which matters the day you sell the house or renew your insurance.

My house still has a fuse box. Is that actually a problem?

It can be two problems. Insurers increasingly refuse to write or renew policies on fuse boxes, and buyers routinely walk at inspection. Beyond that, a 60-amp fuse service simply cannot carry a modern house. Converting to a breaker panel resolves all of it.

Free written estimates

Panel maxed out? Breakers tripping? Let’s take a look.

Tell us what the house is doing and we’ll tell you straight whether it needs an upgrade or a repair.

📞 (412) 899-2364 Request an Estimate

Electrical Panel Upgrades for McKeesport & Greater Pittsburgh Homes

Electric Power Pro Solutions handles the full scope — load calculations, permits, utility coordination, and final labeling — so your new panel is ready to carry a modern household from day one.

What Drives Panel Upgrade Decisions in the Mon Valley

Homes across McKeesport, Duquesne, Clairton, and the surrounding Mon Valley boroughs were largely built during the mid-twentieth century steel era, when a 60-amp or 100-amp service was considered adequate. Today those same houses are running central air conditioning, electric dryers, chest freezers, and multiple device charging stations simultaneously — loads those original services were never sized for.

Allegheny County and the municipalities throughout our service area require a permit and third-party inspection for any service or panel replacement. That inspection record becomes part of the home's file and matters directly when you sell, refinance, or renew a homeowner's policy. Insurers writing policies in this market increasingly flag unpermitted panel work or older fuse-based services as conditions for denial or non-renewal, which means the paperwork we hand you at the end of the job has real dollar value.

Older housing stock in river-valley communities like McKeesport also tends to have knob-and-tube or early aluminum branch wiring in parts of the house, which affects how a panel upgrade is scoped. We note what we find during the estimate so nothing surfaces as a surprise once the work starts.

How to Know Whether Your Panel Actually Needs Replacing

Not every tripping breaker means you need a new panel, and not every full panel means you need a larger service. The honest answer depends on what the load calculation shows. We run those numbers before we quote — comparing your actual connected loads against the panel's rated capacity — so the recommendation we give you is grounded in data, not a default upsell to the next size up.

Signs that do point toward a genuine upgrade: breakers that trip under normal use and reset without a clear fault; a panel that's warm or hot to the touch during regular operation; a service entrance that's visibly damaged, corroded at the weatherhead, or original to a house built before the 1980s; or a sub-panel situation where a previous owner daisy-chained panels to add capacity instead of replacing the main service. Any one of those conditions is worth a conversation.

If the load calculation shows your existing service has headroom and the real problem is a single faulty breaker or a wiring issue downstream, we'll tell you that instead. The estimate is free either way.

Common questions

Will my power be out all day during a panel upgrade?
No — the outage is limited to the window when the utility disconnects and reconnects the service, which we schedule in advance so you can plan around it. The rest of the workday, including prep and final labeling, happens with power on in the parts of the house not directly tied to the main service work.
What size panel do I actually need — 200A or 400A?
That depends on the load calculation, not a rule of thumb. For most single-family homes in the Pittsburgh area, a 200A service is sufficient even with central air, an EV charger, and a generator transfer switch. A 400A service makes sense for larger homes, additions with significant electrical loads, or properties with a detached garage or outbuilding pulling substantial current. We run the numbers first so you're not paying for capacity you won't use.
Does the permit and inspection affect my homeowner's insurance?
Yes, and it matters more than most homeowners expect. In southwestern Pennsylvania, insurers can request proof of permitted electrical work when you apply for coverage, renew, or file a claim. A panel replaced without a permit can trigger a denial or a surcharge. The inspection record we hand you at the end of the job is documentation that the work was done to code — it protects you on closing day and at every renewal after.

Get a Free Estimate on Your Panel Upgrade

Tell us what the house is doing and we'll look at it in person — load calculation, scope, and a written number before any work starts.

Call not on file